Kérdése van? Hívjon! +36-53-571-114
Elfelejtett jelszó
Raktárkészlet: 3 db
ODROID-N2+ is a revision from ODROID-N2. – Maximum CPU clock of Quad-core Cortex-A73 is increased to 2.4Ghz from 1.8Ghz. – Maximum CPU clock of Dual-core Cortex-A53 is increased to 2.0Ghz from 1.9Ghz. – On-board RTC backup battery holder is mounted on the board.
The main CPU is based on big.Little architecture which integrates a quad-core ARM Cortex-A73 CPU cluster and a dual core Cortex-A53 cluster with a new generation Mali-G52 GPU. Thanks to the modern 12nm silicon technology, the A73 cores run at 2.2Ghz without thermal throttling using the stock metal-housing heatsink allowing a robust and quiet computer. The CPU multi-core performance is around 20% faster and the GPU is 10% faster than the N1. The N2+’s DDR4 RAM is running at 1320Mhz with 1.2volt low power consumption. The large metal housing heatsink is designed to optimize the CPU and RAM heat dissipation and minimize throttling. The CPU is placed on the bottom side of the PCB to establish great thermal characteristics.
More information is on our WiKi.
Board Detail
GPIO (40Pin header)
The N2 GPIO interface is similar to C2 and fully supports a 3.3Volt interface while N1 could only support 2.8Volt IO. This is beneficial for using various peripherals without complicated level shifters. Another big improvement is a faster SPI bus interface. Its maximum frequency is over 150Mhz, and we will try to implement a DMA driven SPI driver for faster LCD display.
Power consumption Idle state: 1.6~1.8 Watt Heavy load state: 5.9~6.2 Watt (stress-ng –cpu 6 –cpu-method matrixprod) No cables are attached except DC power input and USB-UART debug console cable.
Software support
Linux Ubuntu 20.04 LTS images are available with Kernel version 4.9.230 LTS as of today. This LTS kernel version will be officially supported until Jan, 2023. The Mali G52 GPU Linux driver works only on the framebuffer and Wayland. We tested the latest PPSSPP emulation and it can handle x3 scaling on a 4K display nicely with well implemented VSYNC. The fb-dev Mali driver supports OpenGL-ES 1.1, 2.0, 3.0 and 3.1 as well as OpenCL-1.2 and 2.0 at this moment. Note that you have to use the Minimal Ubuntu OS image to utilize the GPU acceleration instead of the Ubuntu Mate image.
There is a Linux Wayland driver too. Ubuntu 20.04 Gnome desktop works with fully accelerated hardware GPU on a modern Kernel 5.7. This trial upstream OS image is available on the forum.
Android Android 9 Pie is ready, and you can access a source code BSP and pre-built image together. Note that GUI layer(SurfaceFlinger) resolution is limited at 2K while the video layer is true 4K. The Android platform is based on a full 64bit system software with a Vulkan capable GPU driver.
SBC Specification
Heatsink Dimensions: 100mm x 91mm x 18.75mm
Weight: 200g including heatsink
Quad-core Cortex-A73(up to 2.4Ghz) and Dual-core Cortex-A53 (up to 2Ghz)
ARMv8-A architecture with Neon and Crypto extensions
Mali-G52 GPU with 6 x Execution Engines (800Mhz)
Data rate: 2640 MT/s (PC4-21333 grade)
1.2Volt low power design
1 x microSD slot (DS/HS modes up to UHS-I SDR104)
– Realtek RTL8211F (Ethernet transceiver)
– LED indicators
* Green LED: Flashing by data traffics at 100Mbps connection
* Amber LED: Flashing by data traffics at 1000Mbps connection
Optional WiFi USB adapters
1 x Composite video (3.5mm jack)
1 x HDMI digital output
1 x Optional SPDIF optical output
1 x USB 2.0 OTG port for Host or Device mode. (No power input)
1 x Debug serial console (UART)
1 x Peripheral Expansion Header (40-pin, 2.54mm pitch)
– 2 x DC 5V, 2 x DC 3.3V, 1 x DC 1.8V, 8 x GND
– 1 x SPI
– 1 x UART
– 2 x I2C
– 25 x GPIO (Max)
– 2 x ADC input (10bit, 1.8V Max)
– All 3.3V I/O signal level except for ADC input at max 1.8Volt.
No battery is included in the board.
Please purchase the very common bare CR2032 cell from your local store.
You can keep the RTC time up to several years with a 200mAh CR2032 battery.
8MiB SPI Flash for boot manager
IR receiver for remote controller
Built with a large passive heatsink
System LEDS Indicators:
– Red (PWR) – Solid light when DC power is connected
– Blue (ALIVE) – Flashing like heartbeat while Kernel is running.
Active Cooling Fan Connector (5V 2-pin)
– Connector (2-pin, 1.25mm pitch)
DC 7.5V ~ 18V (up to 25W)
– DC 12V/2A power adaptor is recommended
Power consumption:
– IDLE : ≃ 2.2W (Performance governor)
– CPU Stress : ≃ 5.9W (@2016/2208MHz), 6.2W (@2016/2400MHz)
– Power-off : ≃ 0.2W
Raktárkészlet: több, mint 5db
Raktárkészlet: 5 db
Raktárkészlet: Nincs raktáron
Raktárkészlet: 1 db
Raktárkészlet: 4 db
Raktárkészlet: 2 db
Cookie (süti) kezelési szabályzat
Mik is azok a sütik?
A sütik kis szövegfájlok, melyeket a webhely az oldalaira látogató felhasználó számítógépén, illetve mobilkészülékén tárol el. A sütik segítségével a honlap bizonyos ideig megjegyzi az Ön műveleteit és személyes beállításait (pl. a felhasználói nevet, a betűméretet és a honlap megjelenítésével kapcsolatos többi egyedi beállítást), így Önnek nem kell azokat újra megadnia minden egyes alkalommal, amikor honlapunkra ellátogat, vagy az egyik lapról átnavigál egy másikra.
Hogyan használjuk fel a sütiket?
Webáruházunk sütik segítségével tartja nyilván a következőket:
Bejelentkezés
A sütiknek az engedélyezése nem feltétlenül szükséges a webhely működéséhez, de javítja a böngészés élményét és teljesítményét. Ön törölheti vagy letilthatja ezeket a sütiket, de ebben az esetben előfordulhat, hogy a webhely bizonyos funkciói nem működnek rendeltetésszerűen.
A sütik által tárolt információkat nem használjuk fel az Ön személyazonosságának megállapítására, és a mintaadatok teljes mértékben az ellenőrzésünk alatt állnak. A sütik által tárolt információk kizárólag az itt leírt célokra kerülnek felhasználásra.
A sütik karbantartása
Önnek lehetősége van arra, hogy engedélyezze, letiltsa, karbantartsa és/vagy tetszés szerint törölje a sütiket. Amennyiben változtatni szeretne a beállításon a láblécben található "Cookie beállítások" linken kattintva teheti azt meg.
Bővebb információkért látogasson el az aboutcookies.org. Ön törölni tudja a számítógépén tárolt összes sütit, és a böngészőprogramok többségében le tudja tiltani a telepítésüket. Ebben az esetben azonban előfordulhat, hogy minden alkalommal, amikor ellátogat egy adott oldalra, manuálisan el kell végeznie egyes beállításokat, és számolnia kell azzal is, hogy bizonyos szolgáltatások és funkciók esetleg nem működnek.